Configure the fire alarm zone.
| 1) | Click ZONE and click ADD ZONE. |
| 2) | Click Fire Alarm and click Apply. |
|
|
|
|
1
|
Information
|
Modify the information of the fire alarm zone.
| ▪ | Name: Enter a fire alarm zone name. |
| ▪ | Type: View the zone type. |
|
2
|
Configuration
|
Modify the zone settings of the fire alarm zone.
| ▪ | Mode: You can set fire alarm in two different modes. Local mode will allow the master device and slave devices that are connected via RS-485 to be selected. Global mode will allow selection of all devices added to BioStar 2. |
| ▪ | Active/Inactive: Disable the fire alarm zone. Select Active to enable it. |
| ▪ | Door: Select the door(s) to include in the fire alarm zone. |
| ▪ | Elevator: Select the elevators to include in the fire alarm zone. You can select multiple elevators. |
| ▪ | Device/Input: Click + Add and configure the device to set off the fire alarm signal. |
 Note
| ▪ | When Local is set for Mode, either Door or Elevator can be set as the fire zone. |
| ▪ | When Global is set for Mode, both Door and Elevator can be set as the fire zone at the same time. |
|
3
|
Alarm
|
Choose the operation to be triggered when a fire alarm signal occurs.
|
| 3) | Click Apply to save the settings. |
